Good morning everyone! I'd like to say that I understand very little (or nothing) about projectors. I will soon be moving into a really small house, and I was looking for a projector to replace the TV. However, I have a lot of restrictions on where to put it, the aim would be to get an image of about 80-90 inches (no more, and in case a little smaller) The only two places I could put a projector would be 105 cm away or 610 cm away. Is there something not too expensive that would meet these constraints? Many thanks to those who will try to help me ❤️

  1

Hello. We have a Nokia 3210 4G and a 6300 4g in our household, plus a CatB35 as an outdoor device + modem (usb tethering) for the laptop. All 3 devices are capable of 4G VoLTE with Swisscom and Sunrise. My question: Does VoLTE work with Salt, Spusu or Lidl Connect, does anyone have experience with it? Because these devices are not on the Spusu list.

  1

hello folks, i have a question, i got myself a used ender 3 se (i think it's the se, there are dozens of ender 3 so to be honest i don't know which one i have, i definitely did NOT find it here, never mind .... my question about printers is .... i'm currently printing for about 28 hours ... for one figure .... if i took a more expensive one, would it be faster? .... what else is better about a 500-700 fr printer as opposed to a 260 fr piece? (i've been printing for a week now, so i'm still green behind the ears)

  1

Hi together I have a new mainboard with only digital RGB connectors (ARGB/ D-RGB) I now have a pump that still has a 12V RGB connector. I can't use this now. Now I would need a converter or a controller that would provide the interface to convert the 12V 4-pin cable. So that this can then be plugged into a 5V 3-pin slot for ARGB/D-RGB. It would then also be controllable via the integrated AURA Sync software. Does anyone know of such converters or controllers and can recommend some products? Apparently this is supposed to exist....:-) Unfortunately, I can't find what I'm looking for. Thank you

  2

Hello together I suggest to Digitec that for products shipped via Planzer Paket, an estimated delivery time of 1 - 7 days, or "sometime when it fits" is generally displayed instead of the usual "next day". This would improve communication considerably. It would be easier to decide and the expectations would be more in line with reality. Can something like this be implemented? What do you think? Kind regards Tobias

+88

  143