Dell P2422H
1920 x 1080 pixels, 23.80"
Question about Dell P2422H
I bought the monitor and a cable with a vdi output and a Displayport input. The monitor recognises the cabling but indicates no peripheral dp.... According to Dell customer service, I should try again with a VGA Displayport cable. I ordered one but made a mistake ds male female. Question: I recommended a cable, but aren't there adapters where you can put the cables directly?
Helpful answer
Hello Degendre
I will be happy to try to help you again. However, it is very difficult to get a clear picture without photos of the cabling and the monitor input on the computer. You write "cable with a VDI output", which should probably mean with a "DVI output" (Display Video Interface). This is an interface for the digital and analogue transmission of video data.
Now try the following:
Connect the DP cable supplied with the monitor to the monitor and to the DVI adapter. Then connect the whole thing to the desktop computer. Now switch on the monitor only, without the PC. The monitor will then search for an input from the computer, but will not find one as the computer is switched off. It then goes into stand-by mode. Only now do you start the computer and then the monitor must find the correct input itself.
Good luck and best wishes!
I will be happy to try to help you again. However, it is very difficult to get a clear picture without photos of the cabling and the monitor input on the computer. You write "cable with a VDI output", which should probably mean with a "DVI output" (Display Video Interface). This is an interface for the digital and analogue transmission of video data.
Now try the following:
Connect the DP cable supplied with the monitor to the monitor and to the DVI adapter. Then connect the whole thing to the desktop computer. Now switch on the monitor only, without the PC. The monitor will then search for an input from the computer, but will not find one as the computer is switched off. It then goes into stand-by mode. Only now do you start the computer and then the monitor must find the correct input itself.
Good luck and best wishes!