Safety switch with holding force without magnetic monitoring, holding force 1300 N, for SIMATIC ET200eco PN-F, 5 actuation devices. Spring force locked, magnet voltage DC 24 V, wired with M12 connector, 8-pole. Monitoring 2x door monitoring, 0x locking, PIN1=11, PIN2=12, PIN3=21, PIN4=22, PIN5=n.a., PIN6=n.a., PIN7=E1, PIN8=E2. The corresponding separate actuator 3SE5000-0AV0/-0AW.. must be ordered separately. Connection accessories, e.g., for the SIMATIC ET200eco PN-F: Y-cable, 8-pole cable. Mechanical safety switches SIRIUS 3SE5 for position monitoring of movable protective devices. They ensure that protective doors, covers, or safety flaps/grids remain closed as long as a hazardous condition exists. The drive heads in screwless mounting can be rotated 4x90 degrees. Up to 5 actuation devices of the actuator are possible, one of which can be at the end. The switching elements ensure very high contact reliability and can only be switched with a separately coded actuator that provides increased tamper protection. LEDs conveniently indicate the current status of the device. The devices are globally approved (IEC, UL). With the appropriate switch configuration, the highest safety requirements according to PL e or SIL 3 can be met. The devices are available with spring or magnetic locking, in plastic with a holding force of 1300 N or metal with a holding force of 2300 N. A wide range of 3D coded actuators is available for order. Some variants are optionally available with LED status indication. The 3SF1 series with direct connection to the AS-Interface bus system completes the portfolio. The actuator is not included in the delivery of the safety switches and must be ordered separately. Depending on the version, plugs and other connection accessories are available as accessories. Safety is a SIRIUS business.